BMPRO Customer Support
- Total activity 518
- Last activity
- Member since
- Following 0 users
- Followed by 1 user
- Votes 0
- Subscriptions 262
Articles
Recent activity by BMPRO Customer Support-
The screen on my OdysseyControl is frozen. What do I do?
If the screen on your OdysseyControl is frozen, reset your OdysseyControl by inserting a small thin object, such as a paper clip, into the reset pin hole located on the top of the OdysseyControl.
-
How do I install and pair a SmartSense sensor?
SmartSense sensors are paired differently depending on which BMPRO app you are pairing the sensor to. SmartSense app, JHub, Odyssey, JAYCOMMAND, RVMaster Follow the below instructions. ProSmart Re...
-
How do I install and pair a SmartSense sensor to ProSmart?
To install a SmartSense sensor and pair it to the ProSmart app: Ensure the base of your propane gas tank is clean. Remove any debris, excess paint or rust. In the ProSmart app, press the Settings ...
-
How do I mount the BC300?
The BC300 External Shunt has two mounting terminals. Using these terminals, the BC300 External Shunt is wired in series with the negative terminal of the battery being monitored and the negative ba...
-
How do I install the BC300 and CommLink?
Installation instructions are also available in the BC300 manual. Ensure you are practicing all standard safety precautions during installation. To connect the BC300 External Shunt and CommLink: R...
-
What is the difference between the J35A, the J35B-L and the J35D?
The three models of the J35 battery management system all have different specifications. Feature J35A J35B-L J35D Load Connections 7 14 14 Maximum Current Output 20A 35A 35A Maximum Chargi...
-
My BatteryCharge15 is showing a red LED. What is happening?
The BatteryCharge15 will show a red LED if a fault is detected with the unit. The LED will flash the error code, pause for 2 seconds, then repeat for up to 30 seconds. Touching one of the push butt...
-
My BatteryCharge25 is showing a red LED. What is happening?
The BatteryCharge25 will show a red LED if a fault is detected with the unit. The LED will flash the error code, pause for 2 seconds, then repeat for up to 30 seconds. Touching one of the push butt...
-
How long is the cable on the Dipper?
The Dipper comes with either a 2.5m, 5m or 7.5m cable. You can choose the length of the cable when purchasing a Dipper.
-
My Dipper water tank sensors are not reading the water tank level correctly. What can I do?
Incorrect reading of the water tanks in most cases is due to build up of scum and dirt in the water tanks. This video will help you find out the root cause of the fault. We recommend to clean yo...