
Setec Customer Support
- Total activity 803
- Last activity
- Member since
- Following 0 users
- Followed by 4 users
- Votes 6
- Subscriptions 418
Activity overview
Latest activity by Setec Customer Support-
Setec Customer Support created an article,
If I replace my lead-acid batteries with lithium batteries, what compatibility do I need to consider to ensure my system runs correctly?
Lead-acid and lithium batteries have distinct characteristics, requiring different charging methods and state-of-charge algorithms to ensure accurate monitoring and optimal performance.Some lithium...
-
Setec Customer Support created an article,
What does UPS mean on the PurePro display when it is powered from AC?
If the PurePro display shows “UPS,” it indicates that the unit is functioning as an Uninterruptible Power Supply (UPS). This means it provides backup power if the connected AC mains power source fa...
-
Setec Customer Support created an article,
Can I replace the cable between the XShunt500 and the PXGateway?
No, you cannot. The 2.5m data cable between XShunt500 and the PXGateway is a fixed length and cannot be changed, as this is required for data to be sent properly.
-
Setec Customer Support created an article,
What should I do if the PXShunt500 is not transmitting data?
The state of charge calculation in a BMPRO power management systems uses a learning algorithm to provide accurate data. It can take 3 charge and discharge cycles after either the initial installati...
-
Setec Customer Support created an article,
How do I reset the PXShunt500?
To reset the PXShunt500, disconnect all connections to the battery and the PXGateway, wait for a few minutes, and then reconnect them.
-
Setec Customer Support created an article,
What types of batteries can the PXShunt500 monitor?
The PXShunt500 is designed for 12V batteries up to 1200Ah in capacity.
-
Setec Customer Support created an article,
How do I connect the XShunt500 and the PXGateway?
Remove all the connections to the battery. Connect the PXGateway to the BMPRO power management system CAN bus with the provided data cable. The data cable can be plugged into either CAN 1 or CAN 2...
-
Setec Customer Support created an article,
How do I mount the XShunt500?
Use two appropriately sized screws with a screw head no larger than 12mm to secure the XShunt500 to a solid surface using its two mounting holes. Consider the length of the cables when determi...
-
Setec Customer Support created an article,
What is the PXShunt500 used for?
The PXShunt500 is used for monitoring high current loads in BMPRO power management systems, providing accurate measurements of battery properties like voltage, current, energy usage, and temperatur...
-
Setec Customer Support created an article,
How do I disconnect the BatteryCharge60 from a battery?
Switch off the mains power supply. Remove the BatteryCharge60 negative (-) black cable from the battery terminal. Remove the BatteryCharge60 positive (+) red cable from the battery terminal. Avoi...