How do I install the PurePro?

Installation of the PurePro should only by carried out by suitably qualified personnel. Failure to install the PurePro correctly could result in bodily harm.

The installation location must be dry, clean and well ventilated. Ensure the fan is at least 30mm away from any surrounding objects.

The PurePro2000 requires a DC input wire size of 50mm2, a 250A DC input fuse 250A and a maximum wire length of 1500mm.

The cable must be stranded.

It is recommended a disconnect switch is installed with a rating the same or higher than the rating of the fuse.

The disconnect switch can be used to disconnect the DC input power between the inverter and the battery bank during maintenance or troubleshooting.

To install the PurePro:

1. Secure the PurePro in place using screws in the mounting holes.
2. Check the negative and positive terminals before connecting to ensure the connection is tight.
3. Connect the PurePro to the battery using the battery DC input cables.
4. Connect a GND cable (not supplied) from the PurePro to the installation’s earthing system at the switchboard. The ground wire should be a minimum 2.5mm2 cross-sectional area, comprised of at least 7 strands, and have either green or green/yellow insulation.
5. Turn on the PurePro using the on/off switch.
6. Connect the remote control panel.

You can connect your appliances to the AC output sockets and a USB cable to the USB output.

For instructions on how to install the remote, refer to How do I install the PurePro remote?