Resolving pairing issue instructions for BC300 and CommLink

Only follow these instructions if you have been linked here from another article. Otherwise please click here.

Step 1. Disconnect the positive flylead from the battery and leave it off.         

Step 2. Hold down the button on the CommLink until you see a red flash. This will clear all previous pairings.                                        

An orange light will start flashing from the CommLink.       

Step 3. Make sure you have everything ready to connect up the flylead.                                 

Note: Once you press the button on the CommLink you will have 30 seconds to connect the flylead.                         

Step 4. Press the button on the CommLink. The CommLink will flash blue.                                             

You now have 30 seconds to reconnect the positive flylead back to the battery.                                 

Once connected the BC300 will also flash blue.                  

Step 5. Pairing can take up to 5 minutes. The CommLink will normally flash green first, while the BC300 can be 1-2 minutes behind.               

If both BC300 and CommLink are flashing green, pairing is complete.                                      

Note: If the CommLink flashes red, a connection wasn't made. Steps 1-5 may need to be re-followed.

Has the pairing issue been resolved? If not, please contact BMPRO customer service.